The next picture shows these interfaces types along with a new RouterLink interface in a two-tiered topology.
Follow the steps below to connect Tier-1 Gateway with Tier-0 Gateway.
1 – Login on Edge Gateway and type the following command to list the all routes on Tier-0 Gateway.
Get logical-router
vrf 1
get route
2 – Select Networking > Tier 1 Gateways > Click the three dots > Click edit and then configure linked Tier-0 Gateway and enable “All Connected Segments & Service Ports” and click save.
3 – Go back to the Edge Nodes, run the same commands.
Note: the new learnt routes.
Hoping you have enjoyed this post, see you next time.